i4connected Knowledgebase 5.6

Device temperature and outside temperature delta measurement

Abstract

Check out how the Object delta graph can be used to compare two measurements of the same Device.

Using the Object delta dashboard you can compare two similar measurements of the same object. Proceed as follows to parametrize the Object delta dashboard:

  1. Enter is Edit tile mode by clicking the top toolbar button.

    Edit_tiles_button.jpg
  2. Select the edit option of the Load profile tile,

    Edit_tiles_button.jpg
  3. Expand the Parameters selector under the Edit tile panel.

    Object_delta.jpg
  4. Under the Default section of the Parameters selector panel proceed with the following settings:

    Default_params.jpg
    1. Select the desired KPI(s) used by the chart to plot data.

    2. Define further chart parameters, such as Start date, End date, Measure aggregation, Resolution, etc.

  5. Under the Advanced section of the Parameters selector panel proceed with the following settings:

    Advanced_params.jpg
    1. Click on the Change object filters parameters selector.

    2. In the Edit object filter patterns panel expand the Default options.

    3. Identify the Chose selected items selector and use it to apply your Device.

      Apply_device.jpg
  6. Make sure to preserve the changes by clicking the Save button of the Edit tile panel.

  7. Exist the Edit tile mode.

  8. Open the Load profile panel and start your production Analysis.