i4SCADA Knowledge Base

MessengerPro Web Application Configuration

Abstract

To properly configure the i4SCADA MessengerPro Web Application check out this article and start setting up your environment.

i4SCADA MessengerPro can be configured directly through i4SCADA Studio or by using the web application. This makes possible the configuration of MessengerPro from any visualisation.

The changes made by the user from the visualisation at run time are immediately implemented by i4SCADA MessengerPro.

The WEB Application may be used with multiple browsers: Internet Explorer 11 (or higher), Chrome, Microsoft Edge.

Starting the Web Application

Use the http://servername/_SERVICES/MessengerPro address in the web browser. Replace the “servername” with the name of the computer where i4SCADA MessengerPro is installed. After the initialisation, the login window appears.

Login_dialog.jpg

The Login dialog

The hardware related configuration can be done from i4SCADA Studio, from Settings > Messages > Services.

Messaging_Services.jpg

Messaging Services area

Application

If no valid user is logged in, the application page will initialise the login dialog.

MessPro_Web_Access_Login_page.jpg

MessengerPro Web Access Login page

The authorised users should be found in i4SCADA Studio > Settings > User Manager > Access Groups > System access tab.

For every user with configuration read permission, the system authorisation “MessengerPro: Guest” should be active. If the user is allowed to edit the configuration, the system authoritative “MessengerPro: Administration” should be active.

For additional information about the User Manager, please refer to the i4SCADA Studio documentation.